Insignia 1500 Series Offset Quadrant Steam Shower Bath Cabin 1500mm x 900mm RH - Chrome Frame

The bath and shower and steam and light and radio works and look very nice and materials are good. The assembly manual is missing in the delivery and need to print on line the copy from the online assembly instructions, but how to build it without if your don't have your wifi? The instructions do not show the sticky glue exact locations is in the middle not at the sides and take long time to remove the sticky gum. I did put sticky gum between the magnetic door strips which are a bit loose and making noise and the door magnetic small seal as supplied did came out easy and does not fit properly. The bath levelling is ok if you have a perfect flat bathroom floor and should set from the factory at horizontal level, but it took me 3 days because I had to fit 1 cm multiplex wood cover over a central heating pipe hole where the rear corner support was located and the alignment leg travel is just not enough for the other support to get the level right, it would also help if the front panel can be removed so you can see visual if all supports are flat on the floor and would be more easy to level the bath. I had to lift it in place in the corner of the wall first over existing CV pipe lines, then it become very hard to get the screws in of the back panels and in special roof panel is impossible because the bath is top heavy with the panels mounted in place when it sits against the corner walls. But I managed to install it and took me 5 days in total. The water hose from the column to the steam generator water supply consist out 2 hoses and a straight copper union supplied with the 4 hoses , not clear in the instructions. and have one cold and one hot water supply hose fitted to the central column connections. One assembly drawing shows the top rail bolt holes at the bottom and shows in the details the correct location in the top. But is was all worth the money and the time spend to build it, and hope that it will last long time. Insignia supplied the steam diffuser but not the oil sample to test it out, that would be better selling for the oil I think. The 2 cables with plug are too short to be installed in the safe zones, I did fit an outdoor double socket and left an 8 cm gap for access at the rear wall below the bad, but it would be better if the power to the steam generator and bath column on/off water proof IP66 switches are build in the bath side for more easy access. Hope my comments help others installing it and the manufacture to improve the design.